Is your calibre in the books?

As an eBay Partner Network affiliate, Watch Breaker earns from qualifying purchases.

Type the number off the movement. This tells you which reference sheet covers it — identification, technical bulletin, or both — before you pay anybody anything.

The whole set, laid out.

Nine sheets of American Watchmakers Institute microfiche. Identification sheets run to 1655. Technical bulletins run to 4315. Anything above that comes out of the GF 620 factory catalogues instead.

SECTION I — MOVEMENT & PARTS IDENTIFICATION

SECTION II — TECHNICAL BULLETINS

SECTION III — SUPPLEMENTAL

Covered isn't the same as correct.

Knowing the sheet exists tells you the answer is findable. It doesn't tell you whether the movement in your watch is the one the case was built for, whether the dial has been refinished, or whether the crown and hands are later service parts.

Not sure of the number? The calibre is stamped on the movement itself, usually on a bridge or under the balance. Photograph it and send it over — I'll read it for you.

Questions people ask

Is there a service manual for Omega calibre X?

Not by that name. Omega's documents for its vintage calibres are the GF 620 spare-parts catalogues, which give every part and its number calibre by calibre, and for some calibres a technical guide. The 1950s–60s guides cover specs, oiling and special parts; from 1970 on, the guides give the full order of assembly. Our films show each calibre's parts in bench order, with the factory number on screen. Check which documents cover your calibre with the coverage checker. The full answer: Is there a service manual for your vintage Omega?